3/4" Simpson MCR07512 Rebar Cutter Finish Nails Square Single Channel 2-Hole Post

Square Single Channel 2-Hole Post Base - 304 Stainless Steel is a post base designed to fasten Strut Channel to the floor

The length of the bolt inside the anchor should not exceed 5"

The DSSCB is used to anchor cold-formed steel bypass framing to the edge of a floor slab in order to accommodate horizontal building drift

Suited for board-to-steel applications with steel up to approximately 0

Alignment: Ensure the hanger is fully seated around the joist for a tight

3/4" Simpson MCR07512 Rebar Cutter Finish Nails Square Single Channel 2-Hole PostWhen hole placement conflicts with rebar or wire mesh, these bits allow the rebar to be removed so the hole can be drilled to the proper depth. Simpson rebar cutters are separate from shanks. A shank adaptor designed for the rotohammer in use is required (sold separately). Shanks work will all sizes of rebar cutters. The overall length of this rebar cutter is approximately 15".